Removal

2GR-FE LUBRICATION: OIL PUMP: REMOVAL

1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

Removal

2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY Removal

3. INSTALL ENGINE ON ENGINE STAND Removal

4. REMOVE ENGINE HANGERS Removal

5. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal

6. REMOVE NO. 1 SURGE TANK STAY Removal

7. REMOVE THROTTLE BODY BRACKET Removal

8. REMOVE IGNITION COIL ASSEMBLY Removal

9. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH Removal

10. REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE Removal

11. REMOVE NO. 2 MANIFOLD STAY Removal

12. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR Removal

13. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal

14. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY Removal

15. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE Disassembly

16. REMOVE NO. 2 TIMING GEAR COVER Removal

17. REMOVE WATER PUMP PULLEY Removal

18. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY Removal

19. REMOVE NO. 1 VACUUM SWITCHING VALVE Removal

20. REMOVE CRANK POSITION SENSOR Removal

21. REMOVE NO. 1 OIL PIPE Disassembly

22. REMOVE OIL PIPE Disassembly

23. REMOVE CRANKSHAFT PULLEY Removal

24. REMOVE NO. 1 FRONT ENGINE MOUNTING BRACKET LH Disassembly

25. REMOVE WATER INLET HOUSING Removal

26. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY Disassembly

27. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH Disassembly

28. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY Disassembly

29. REMOVE OIL STRAINER SUB-ASSEMBLY Disassembly

30. REMOVE OIL PAN SUB-ASSEMBLY Disassembly

31. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

(a) Remove the 23 bolts and 2 nuts shown in the illustration.





Text in Illustration





(b) Remove the timing chain cover by prying between the timing chain cover and cylinder head or cylinder block with a screwdriver.





Text in Illustration





NOTICE:
Be careful not to damage the contact surfaces of the cylinder head, cylinder block and chain cover.

HINT
Tape the screwdriver tip before use.

(c) Remove the gasket.





32. REMOVE TIMING CHAIN CASE OIL SEAL

(a) Using a screwdriver and wooden block, pry out the oil seal.





Text in Illustration





HINT
Tape the screwdriver tip before use.