Removal

PARKING BRAKE: PARKING BRAKE CABLE: REMOVAL

HINT
* The following procedure is for the No. 1 parking brake cable assembly and No. 3 parking brake cable assembly.
* Use the same procedure for the No. 3 parking brake cable assembly and No. 2 parking brake cable assembly.

1. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY

Removal

2. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Pull up the parking brake pedal claw.

NOTICE:
Do not damage the No. 1 parking brake cable assembly.

(b) Remove the adjusting nut.

(d) Remove the No. 1 parking brake cable assembly from the parking brake pedal assembly.

3. REMOVE REAR DOOR SCUFF PLATE LH Removal

4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

(a) Disconnect the rear door opening trim weatherstrip LH.

5. REMOVE LAP BELT OUTER ANCHOR COVER (for LH Side) Removal

6. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Removal

7. REMOVE CENTER PILLAR LOWER GARNISH LH Removal

8. REMOVE REAR DOOR SCUFF PLATE RH Removal

9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT
Use the same procedure as for the LH side.

10. REMOVE LAP BELT OUTER ANCHOR COVER (for RH Side) Removal

11. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Removal

12. REMOVE CENTER PILLAR LOWER GARNISH RH Removal

13. REMOVE FRONT SEAT ASSEMBLY LH

* for TMMK Made Manual Seat: Removal

* for TMMK Made Power Seat: Removal

* for SIA Made Manual Seat: Removal

* for SIA Made Power Seat: Removal

14. REMOVE FRONT SEAT ASSEMBLY RH

HINT
Use the same procedure as for the LH side.

15. REMOVE AUDIO AMPLIFIER COVER (for 10 Speakers) Removal

16. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET (for 10 Speakers) Removal

17. REMOVE AUDIO AMPLIFIER COVER (w/ Manual (SOS) Switch) Removal

18. REMOVE DCM (TELEMATICS TRANSCEIVER) WITH BACK-UP BATTERY (w/ Manual (SOS) Switch) Removal

19. REMOVE FLOOR CARPET HOOK Removal

20. REMOVE NO. 4 CROSS MEMBER FLOOR REINFORCEMENT SUB-ASSEMBLY

(a) Remove the screw.

(b) Disengage the guide to disconnect the fuel lid lock open lever sub-assembly as shown in the illustration.

(c) Turn back the floor carpet to a position where the No. 4 cross member floor reinforcement sub-assembly can be removed.

(d) Remove the 8 bolts and No. 4 cross member floor reinforcement sub-assembly.

21. REMOVE NO. 4 PARKING BRAKE CABLE ASSEMBLY

(a) Separate the No. 3 parking brake cable assembly from the parking brake equalizer.

Text in Illustration

(b) Separate the No. 2 parking brake cable assembly to remove the parking brake equalizer.

(c) Slide the parking brake equalizer and rubber boot.

Text in Illustration

(d) Remove the No. 4 parking brake cable assembly from the parking brake equalizer.

22. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2AR-FE)

Removal

23. REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR (for 2AR-FE)

(a) Remove the 3 nuts and front No. 2 floor heat insulator.

24. REMOVE PARKING BRAKE SHOE LEVER

Disassembly

25. REMOVE NO. 2 FLOOR UNDER COVER (for LH Side)

(a) w/ Floor Under Cover:

(1) Remove the 2 bolts and 2 clips.

Text in Illustration

(2) Disengage the 3 nuts and remove the No. 2 floor under cover.

26. REMOVE NO. 1 FLOOR UNDER COVER (for RH Side)

(a) Remove the 2 bolts.

Text in Illustration

(b) Disengage the 3 nuts and 2 clips, and remove the No. 1 floor under cover.

27. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the clip from the No. 3 parking brake cable assembly.

(b) Remove the bolt and separate the No. 3 parking brake cable assembly.

28. REMOVE NO. 2 PARKING BRAKE CABLE CLAMP

(a) Remove the No. 2 parking brake cable clamp.