Installation

FRONT SUSPENSION: FRONT STABILIZER BAR: INSTALLATION

1. INSTALL FRONT NO. 1 STABILIZER BAR BUSH






(a) Install the 2 bushes to the outer side of the bush stoppers on the front stabilizer bar as shown in the illustration.
NOTICE:
Be sure to install the front No. 1 stabilizer bar bushes so that the cut and bump of each bush faces the under of the vehicle.

2. INSTALL FRONT STABILIZER BAR






(a) Set the stabilizer bracket so that the arrow mark is facing the front side of the vehicle.






(b) Temporarily install the 2 stabilizer brackets and front stabilizer bar with the 4 bolts.
3. TEMPORARILY INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Temporarily install the stabilizer link with the nut and bolt.






(b) Tighten the nut.
Torque: 128 Nm (1305 kgf-cm, 94 ft-lbf)
4. TEMPORARILY INSTALL FRONT STABILIZER LINK ASSEMBLY RH






(a) Temporarily install the stabilizer link with the nut and bolt.
(b) Tighten the nut.
Torque: 128 Nm (1305 kgf-cm, 94 ft-lbf)
5. TIGHTEN FRONT NO. 1 STABILIZER BRACKET LH






(a) Tighten the 2 bolts.
Torque: 87 Nm (887 kgf-cm, 64 ft-lbf)
HINT:
Tighten the bolts in 3 steps, in the order shown in the illustration.

6. TIGHTEN FRONT NO. 1 STABILIZER BRACKET RH






(a) Tighten the 2 bolts.
Torque: 87 Nm (887 kgf-cm, 64 ft-lbf)
HINT:
Tighten the bolts in 3 steps, in the order shown in the illustration.

7. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation

8. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Installation

9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Installation

10. STABILIZE SUSPENSION Installation

11. TIGHTEN FRONT STABILIZER LINK ASSEMBLY LH






(a) Tighten the bolt.
Torque: 135 Nm (1376 kgf-cm, 100 ft-lbf)
NOTICE:
Perform this procedure with all 4 wheels on the ground.

12. TIGHTEN FRONT STABILIZER LINK ASSEMBLY RH






(a) Tighten the bolt.
Torque: 135 Nm (1376 kgf-cm, 100 ft-lbf)
NOTICE:
Perform this procedure with all 4 wheels on the ground.