Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION

1. INSTALL SPIRAL CABLE






(a) Align the pins on the spiral cable with the installation holes on the steering sensor.
(b) Attach the 6 claws and install the spiral cable to the steering sensor.
(c) Check that the front wheels are facing straight ahead.
(d) Set the turn signal switch to the neutral position.
CAUTION:
If it is not in the neutral position, the pin of the turn signal switch may be snapped.





(e) Attach the 3 claws to install the spiral cable with steering sensor.
CAUTION:
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.


(f) Connect the connectors to the spiral cable with steering sensor.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL UPPER STEERING COLUMN COVER Installation

3. INSTALL LOWER STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
- w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.





(c) Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
CAUTION:
Do not turn the spiral cable with steering sensor by the airbag wire harness.






(d) Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
CAUTION:
Do not turn the spiral cable with spiral sensor by the airbag wire harness.

HINT:
The spiral cable with steering sensor will rotate approximately 2.5 turns to both the left and right from the center.

5. INSTALL STEERING WHEEL ASSEMBLY Installation

6. INSTALL STEERING PAD Installation

7. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

8. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSTALL ENGINE ROOM SIDE COVER LH Installation

11. INSPECT STEERING PAD Installation

12. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.