Ignition Coil: Service and Repair

Ignition Coils

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

Removing

- Remove the engine compartment trim - 1 - or - 3 -. Refer to => [ Engine Compartment Trim ] Engine Compartment Trim.





Removing Cylinder Bank 1 (right):

- Remove the bolts - 1 - and - 2 -.





- Release electrical connectors and remove connectors simultaneously from ignition coils.

- Pull ignition coils approximately 30 mm out of spark plug shaft using (T40039).





Removing Cylinder Bank 2 (left):

- Remove the bolts - 1 - and - 2 -.





- Pull ignition coils approximately 30 mm out of spark plug shaft using (T40039).





- Release electrical connectors and remove connectors simultaneously from ignition coils.

Installing the Ignition Coils

- Insert all ignition coils loosely into spark plug shaft.

- Align the ignition coils to the connectors and then connect all of the connectors simultaneously onto the ignition coils.

- Press the ignition coils uniformly onto the spark plugs by hand (do not use an impact tool).

- Install the engine compartment trim.

Tightening Specifications