Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION

INSTALLATION

1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for least 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Temporarily install the front airbag sensor with the 2 claws and pin.
(d) Install the front airbag sensor with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- Make sure that the pin is securely inserted into the body hole.
- Tighten the bolt while holding the front airbag sensor because the front airbag sensor claws and pin (stopper) are easily damaged.

(e) Check that there are no loose parts after installing the front airbag sensor.
(f) Connect the connector to the front airbag sensor.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL HEADLIGHT ASSEMBLY Installation

3. INSTALL REAR FENDER SPLASH SHIELD SUB-ASSEMBLY Installation

4. INSTALL FRONT BUMPER ASSEMBLY (w/o Fog Light) Installation

5. INSTALL FRONT BUMPER ASSEMBLY (w/ Fog Light) Installation

6. INSTALL RADIATOR GRILLE Installation

7. INSTALL COOL AIR INTAKE DUCT SEAL Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization

9. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT Adjustments

10. PREPARATION FOR HEADLIGHT AIMING (Using a headlight aim test machine) Adjustments

11. PREPARATION FOR HEADLIGHT AIMING (Using a Screen) Adjustments

12. INSPECT HEADLIGHT AIMING Adjustments

13. ADJUST HEADLIGHT AIMING Adjustments

14. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) Adjustments

15. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

16. INSPECT FOG LIGHT AIMING (w/ Fog Light) Adjustments

17. ADJUST FOG LIGHT AIMING (w/ Fog Light) Adjustments

18. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.