Front

Wheel Speed Sensor Replacement - Front
Removal Procedure





Caution
Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.

Notice
Refer to Vehicle Lifting and Jacking Notice in Service Precautions.

2. Raise and suitably support the vehicle.
3. Disconnect the electrical connector from the front wheel speed sensor.
4. Remove the bolt and the front wheel speed sensor from the steering knuckle.

Installation Procedure





Notice
Refer to Fastener Notice in Service Precautions.

1. Install the bolt and front wheel speed sensor to the steering knuckle.
Tighten the bolt to 9 Nm (7 ft. lbs.).
2. Connect the electrical connector to the front wheel speed sensor.
3. Lower the vehicle.
4. Connect the negative battery cable.