Camshaft Position (CMP) Sensor LH

Camshaft Position (CMP) Sensor LH

Removal
1 Remove the intake air resonator. For additional information, refer to Intake Air Resonator Service and Repair




2 Disconnect the CMP sensor electrical connector.
- Slide the red connector latch to one side.




3 Remove the CMP sensor.
- Remove the Torx bolt.
- Remove and discard the O-ring seal.

Installation
1 Install the CMP sensor.
- Clean the components.
- Install a new O-ring seal.
- Tighten the Torx bolt to 7 Nm (5 lb.ft).
- Connect and secure the electrical connector.
2 Install the intake air resonator. For additional information, refer to Intake Air Resonator Service and Repair