Interior - Power Seats Inoperative

NUMBER
XK501-006

MODEL
2007 XK

DATE
21 Dec 2006

SECTION: 501-11 - SEATING

Front Seat Will Not Move in Response to Controls

AFFECTED VEHICLE RANGE:
New XK

VIN:
B00001 to B04774

Model Year:
2007

CONDITION SUMMARY:

FRONT SEAT WILL NOT MOVE IN RESPONSE TO CONTROLS

Situation:
A customer may report a concern of no movement of the driver or passenger front seat, in any direction. A seat module ignoring the "wake-up" request may be the cause.

Action:
Should this concern be verified, refer to the Repair Procedure detailed in this bulletin to reconfigure the Driver Seat Module (DSM) and the Passenger Seat Module (PSM) using the Integrated Diagnostic System (IDS).

PARTS:
No parts required. Information purposes only.

TOOLS:
IDS DVD 103 (or later) software installed

WARRANTY:





NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal warranty policy and procedures apply.

REPAIR PROCEDURE

RECONFIGURE DRIVER SEAT MODULE (DSM) AND PASSENGER SEAT MODULE (PSM)

NOTE:
This procedure requires IDS DVD103 software or later.

CAUTION:
A Midtronics PSC-550 Vehicle Power Supply must be connected to the vehicle battery during diagnosis and module configuration.

1. Connect the Midtronics PSC-550 power supply to the vehicle battery.

2. Connect IDS to the vehicle and begin a new diagnostic session, by entering the correct VIN for the current vehicle.

3. Follow the IDS prompts to read the vehicle configuration.

NOTE:
Any associated diagnostic routines should be carried out as a separate Warranty claim.

4. Carry out any associated diagnostic routines and clear any fault codes.

5. When prompted 'Do you wish to read diagnostic trouble codes?', select 'NO' and then press 'tick' to continue.

6. When the 'Content Model' is displayed select 'Vehicle Configuration' tab.

7. From the 'Vehicle Configuration Menu' select 're-configure existing modules'.

8. From the sub-menu select 'DSM' and allow the module re-configuration to be completed.

9. From the sub-menu select 'PSM' and allow the module re-configuration to be completed.

10. Follow all on-screen instructions to complete this task.

11. When the task is completed, exit the current session.

12. Disconnect IDS and the power supply from the vehicle.





Disclaimer