Fluid Filter - A/T: Service and Repair

Oil Filter

Removing

• General repair information. Refer to => [ General Repair Information ] General Repair Information.

• Rules of cleanliness for working on transmissions. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Remove the oil pan. Refer to => [ Oil Pan ] Service and Repair.

- Carefully remove oil filter - A - from the transmission.





Installing

Install in the reverse sequence; note the following points:

• The filter only requires replacement when it is damaged.

If the oil filter is replaced, observe the following





- If present, carefully remove the oil filter seal - A - from the transmission, e.g. with a screwdriver.

• Do not damage sealing surface.

• The seal is shown with the mechatronic unit removed to provide a better illustration.

• The new filter is supplied with the seal in place.

Continuation for new and old filters





- Carefully press oil filter intake tube - A - into the opening in the transmission until fully seated.

• A new oil filter with attached seal is pressed into the transmission.

- Install the oil pan. Refer to => [ Oil Pan ] Service and Repair.