Oil Pan, Oil Pump, Assembly Overview

Oil Pan, Oil Pump, Assembly Overview





1 Oil Level Thermal Sensor (G266)

• not on engine codes CBFA, CCTA and CCTB

2 Gasket

• Replace

3 Bolt

• Replace

• Tightening order => [ Oil Pan, Lower Part, Tightening Sequence ]

4 Lower oil pan section

• Removing and installing => [ Oil Pan Lower Section, Removing and Installing ] Oil Pan Lower Section, Removing and Installing

5 Bolt

• 9 Nm

6 Oil baffle

• Replace

7 Bolt

• 9 Nm

8 Oil pump

• Removing and installing => [ Oil Pump, Removing and Installing ] Service and Repair

9 Centering sleeve

10 Chain tensioner

11 Bolt

• 9 Nm

12 Drive chain for oil pump

• Mark direction of rotation before removing

13 Oil pan (upper section)

• Removing and installing => [ Oil Pan, Upper Section, Removing and Installing ] Oil Pan, Upper Section, Removing and Installing

14 Bolt

• 9 Nm

15 Bolt

• Replace

• Tightening order => [ Oil Pan, Upper Part, Tightening Sequence ]

16 Flat sealing ring

17 Suction line

• Clean strainer if soiled

18 O-ring

• Replace

19 O-ring

• Replace

20 Non-return valve

21 Oil drain plug

• 30 Nm

22 Nut

• 9 Nm

Oil Pan, Lower Part, Tightening Sequence





- Tighten the bolts - 1 through 20 - in 2 stages as follows:

- Tighten the bolts to 8 Nm.

- Tighten the bolts an additional 90°.

Oil Pan, Upper Part, Tightening Sequence





- Tighten the bolts - 1 through 14 - in 2 stages as follows:

- 1. Tighten the bolts to 15 Nm.

- 2. Tighten the bolts an additional 90°.

Oil separator, tightening sequence





- Tighten bolts to 9 Nm in the sequence - 1 to 9 -.