Headliner

Roof Trim

Headliner

Removing

Vehicles with sunroof

- Open sunroof.

All vehicles

- Switch off ignition.

Vehicles in which an interior rearview mirror with rain sensor is installed

- Remove the interior rearview mirror with rain sensor. Refer to => [ Interior Rearview Mirror with Rain Sensor ] Interior Rearview Mirror

All vehicles

- Remove the front and rear interior and reading lamps in the headliner

- Remove storage compartment with console in headliner. Refer to => [ Storage Compartment with Console in Headliner ] Storage Compartments, Covers and Trim

- Remove upper trim on A-pillars. Refer to => [ Upper A-Pillar Trim ] Pillar Trim

- Remove sun visors.

• Basic: => [ Basic Sun Visors ] Storage Compartments, Covers and Trim

• Double: => [ Double Sun Visors ] Storage Compartments, Covers and Trim

- Remove roof grab handle.

- Fold the front seat backrests forward.

- Remove upper B-pillar trim. Refer to => [ Upper B-Pillar Trim ] Pillar Trim

- Remove trim on C-pillars:

• Vehicles without sun shade: => [ C-Pillar Trim without Sun Shade ] Pillar Trim

• Vehicles with sun shade: => [ C-Pillar Trim with Sun Shade ] Pillar Trim

- Remove roof end strip, sedan. Refer to => [ Roof End Strip ] Roof End Strip

Vehicles with sunroof

- Push the (T10039/1) between frame - 1 - and headliner - 2 -.

- Using the (T10039/1), separate the frame in - direction of the arrow - from the headliner, the whole way around.





All vehicles

- In rear window transition area, remove four screws - 1 - (2 Nm).

- Remove headliner from door seal moldings.

- Lower headliner slightly and (depending on vehicle equipment) disconnect wiring harnesses from headliner.





Installing

- Installation is in reverse order of removal.

• The installation of the headliner is made much easier by replacing clips "part number: 1K0 867 633" below the roof grab handle.