Dual Mass Flywheel

Dual Mass Flywheel

Special tools, testers and auxiliary items required

• Counter-Holder Tool (T10044)

Removing

• To prevent damage to the dual mass flywheel when removing, the bolts - B - must not be removed using an air powered or impact wrench. Only removing the bolts - B - by hand is permitted.

- Rotate the dual mass flywheel - A - so that the bolts - B - are centered with the holes - arrows -.






- When unscrewing bolts - B -, make sure that the bolt head is not jammed on the flywheel.

- Install the (T10044) with a washer - arrow - to the cylinder block. Move the (T10044) into - position A - in order to loosen the flywheel bolts.






- Mark the flywheel to engine.

- Remove flywheel.

Installing:

Install in reverse order of removal. Note the following:

- Replace the bolts.

Install the (T10044) into - position B - in order to tighten the flywheel bolts.






Tightening Specifications






1) 90° corresponds to a 1/4 turn