Crankshaft, Cylinder Block -Fastener Tightening Specifications

Fastener Tightening Specifications

Tightening Sequence, Accessory Bracket to Cylinder Block





- Place accessory bracket on cylinder block (observe fitting sleeve between bracket and cylinder block).

- Tighten the bracket bolts in tightening sequence as follows:

1. Tighten bolt - A - to 45 Nm

2. Tighten bolt - B - to 45 Nm

3. Tighten bolt - C - to 45 Nm

4. Tighten bolt - D - to 45 Nm

5. Tighten bolt - E - to 45 Nm

6. Tighten bolt - F - to 45 Nm