Ribbed Drive Belt

Ribbed Drive Belt

Special tools, testers and auxiliary items required

• Drift (T10060A)

Removing

- Remove noise insulation

- Remove engine cover.

One Piece Engine Cover





Pull the one piece front engine cover - arrows A - upward with a quick jerk and then pull the lower mount - arrow B - forward.

Two Piece Engine Cover





On the two piece engine cover, first pull the outer cover upward with a quick jerk - arrows in the upper illustration -, then pull the inner engine cover upward with a quick jerk - arrows in lower illustration -.

Fuel Filter Without the Retaining Plate

- Release the retainers, pull the fuel filter with connected hoses upward and out of the retaining plate - arrow - and lay it aside.





Fuel Filter With the Retaining Plate

- Loosen the bolt - 1 - one turn.





- Remove the bolt - 2 - and the nut - 3 -.

- Lay the fuel filter, with the hoses still connected, to the side.

Continuation for All

- Mark direction of rotation of ribbed belt.

- Pivot tensioner element in - direction of arrow - to relieve tension on ribbed belt.





- Secure tensioner element using the drift (T10060 A).





- Remove ribbed belt.

Installing

- Installation is performed in reverse order. When doing this note the following:

• Before installing ribbed belt, make sure that all ancillaries (alternator, air conditioner compressor) are secured tightly.

• Note previously marked direction of belt rotation and be sure that it is seated correctly on pulley.

• Set the ribbed belt onto the generator lastly.

After completing repairs always:

- Start the engine and check the running belt.

Belt Routing Without Air Conditioning





1. Pulley - crankshaft

2. Ribbed belt

3. Tensioner

4. Pulley - generator

Belt Routing With Air Conditioning





1. Pulley - crankshaft

2. Ribbed belt

3. Tensioner

4. Pulley - generator

5. Pulley - air conditioning compressor