Clutch Pedal and Over-Center Spring

Clutch Pedal And Over-center Spring, Removing And Installing

Removing

- Remove cover below instrument panel. Interior Moulding / Trim

Notes:






Make sure that the clutch pedal switch -arrow- is not pressed out of the securing clip. The thread of the switch will be damaged and the switch must be replaced.

In order to guaranteed sufficiently secure seating , you can install the clutch pedal switch -arrow- one time only.






- Detach clutch pedal from master cylinder by prying out securing clip for pin with screwdriver -arrow 2- and pulling out pin -arrow 2-






- Press clutch pedal securing clip -arrow 1- off pivot pin with a screwdriver.
- Remove plug -arrow 2-
- Press clutch and brake pedal pivot pin out to right, until clutch pedal can be removed.
- If necessary press brake pedal securing clip off pivot pin with a screwdriver.
- Take out clutch pedal and over-center spring.

Installing

The installation procedure is the reverse of the removal sequence, when installing note the following:






- Align clutch pedal/brake pedal pivot pin so that it protrudes from mounting bracket on clutch pedal side (arrow).
- Press clutch pedal onto stop and insert over-center spring in its seat on clutch pedal.
- Now put clutch pedal in the pivot pin and push it to the left until securing clip cam be attached
- Connect master cylinder to clutch pedal and engage securing clip for pin in clutch pedal






- Do not tighten bolt -arrow 2- until both securing clips -arrow 1- for clutch pedal; clip for brake pedal (not visible) have been installed on the clutch pedal/brake pedal pivot pin.
- Adjust clutch pedal switch above clutch pedal.