Selector Lever, Disassembling and Assembling

Selector lever, disassembling and assembling
Lubricate mounting points and contact surfaces with grease Pad No. G 052 142 A2.





1. Detent plate
^ Before installing the selector lever in selector housing, assemble selector lever, detent plate, spring, locking lever and pivot piece.
2. Spring For locking lever
^ Hook into hole of detent plate
3. Locking lever
^ For vehicles with ignition key removal lock
4. Pivot piece
5. Combi-bolt
6. Relay lever
7. Bolt Tightening - 20 Nm -
^ For securing the selector lever cable
8. Hex nut, 25 Nm
^ Always replace
9. Locking lever
^ Insert with spring and bushing into the selector lever
10. Spring
^ Insert with locking lever and bushing into the selector lever
11. Bushing
^ Insert in locking lever
12. Hex bolt, 3 Nm
^ Install with locking fluid AMV 185 101 A1
13. Shift lock solenoid -N110-
^ Can be checked in electrical test and in measured value block
14. Slide
^ Press into the selector lever hole
15. Set screw
^ Install with locking fluid AMV 185 101 A1
16. Selector lever
^ Assemble before installing in selector lever housing
17. Spring
18. Push rod
^ Grease in area of sliding surfaces