Removal

2ZR-FXE EMISSION CONTROL: CANISTER: REMOVAL

1. REMOVE CHARCOAL CANISTER ASSEMBLY

(a) Disconnect the 3 wire harness clamps and connector.





(b) Disconnect the air line tube.





Text in Illustration





NOTICE:
* Remove any dirt or foreign matter on the tube connector before performing this work.
* Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connector has an O-ring that seals the pipe.
* Perform this work by hand. Do not use any tools.
* Do not forcibly bend, twist or turn the air line tube.
* Protect the disconnected parts by covering them with plastic bags after disconnecting the air line tube.
* If the tube connector and pipe are stuck, push and pull on them to release.

(1) Push the air line tube firmly toward the charcoal canister side.

(2) Pinch the air line tube as shown in the illustration.

(3) Pull out the air line tube.

(c) Disconnect the purge line hose.





(d) Disconnect the fuel tank vent hose.





Text in Illustration





HINT
Do not remove the retainer.

NOTICE:
* Remove any dirt or foreign matter on the tube connector before performing this work.
* Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connector has an O-ring that seals the pipe.
* Perform this work by hand. Do not use any tools.
* Do not forcibly bend, twist or turn the fuel tank vent hose.
* Protect the disconnected parts by covering them with plastic bags after disconnecting the fuel tank vent hose.
* If the tube connector and pipe are stuck, push and pull on them to release.

(e) Disconnect the vent line tube.





Text in Illustration





HINT
Do not remove the retainer.

NOTICE:
* Remove any dirt or foreign matter on the tube connector before performing this work.
* Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connector has an O-ring that seals the pipe.
* Perform this work by hand. Do not use any tools.
* Do not forcibly bend, twist or turn the vent line tube.
* Protect the disconnected parts by covering them with plastic bags after disconnecting the vent line tube.
* If the tube connector and pipe are stuck, push and pull on them to release.

(f) Remove the 3 bolts, guide and charcoal canister assembly.





2. REMOVE CHARCOAL CANISTER WITH BRACKET ASSEMBLY

(a) Remove the nut.





Text in Illustration





(b) Disengage the claw and pull out the charcoal canister with bracket assembly.