Installation

BRAKE SYSTEM (OTHER): BRAKE PEDAL: INSTALLATION

1. INSTALL BRAKE PEDAL PAD

2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

(a) Install the nut to the brake pedal support assembly.

(b) Install the brake pedal support assembly with the 4 nuts.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(c) Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.





Text in Illustration









for Bolt A - Torque : 14 Nm (140 kgf-cm, 10 ft-lbf)

for Bolt B - Torque : 24 Nm (241 kgf-cm, 17 ft-lbf)

HINT
Two types of bolts each with a different torque specification are used.

3. INSTALL PUSH ROD PIN

(a) Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal sub-assembly.

(b) Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal support assembly.

4. INSTALL BRAKE PEDAL RETURN SPRING

(a) Install the brake pedal return spring to the brake pedal support assembly and push rod pin.

5. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

6. INSTALL STOP LIGHT SWITCH ASSEMBLY Installation

7. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY Installation

8. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

11. INSTALL POWER STEERING ECU ASSEMBLY

Installation

12. INSPECT AND ADJUST BRAKE PEDAL

Adjustments

13. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

Initialization