Component Tests and General Diagnostics

BRAKE SYSTEM (OTHER): BRAKE FLUID: ON-VEHICLE INSPECTION

NOTICE:
If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decreased efficiency.

HINT
If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brake pad wear. After repair or replacement, adjust the brake fluid level in the reservoir as specified below.

1. INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (for Using the Techstream)

(a) Connect the Techstream to the DLC3 with the ignition switch off.

(b) Check that the shift lever is in P and the parking brake is applied, and turn the ignition switch to ON (IG).

(c) Turn the Techstream on and enter the following menus: Chassis / ABS/VSC/TRAC / Utility / ECB (Electronically Controlled Brake system) Utility / Zero Down.

(d) Select "Next" and wait for 10 seconds.

(e) After the booster pump has stopped, inspect that the fluid level is between the MAX and MIN lines. If necessary, refill the brake fluid to the MAX line.





Text in Illustration





Brake fluid:

SAE J1703 or FMVSS No. 116 DOT3

2. INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (for not Using the Techstream)

(a) Inspect that the fluid level is above the MIN line with the ignition switch ON (IG). If necessary, refill the brake fluid to the fluid level support line with the ignition switch ON (IG).





Text in Illustration





Brake fluid:

SAE J1703 or FMVSS No. 116 DOT3