Installation

U660E AUTOMATIC TRANSMISSION / TRANSAXLE: VALVE BODY ASSEMBLY: INSTALLATION

1. INSTALL MANUAL VALVE

(a) Coat the manual valve with ATF and install it to the valve body.

2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

(a) Coat the O-ring of the transmission wire with ATF.

(b) Confirm that the manual valve lever is positioned as shown in the illustration and install the valve body assembly to the transaxle case with the 11 bolts.





Text in Illustration





Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

Bolt length:

Bolt A
25 mm (0.984 in.)

Bolt B
30 mm (1.18 in.)

Bolt C
35 mm (1.38 in.)

Bolt D
45 mm (1.77 in.)

Bolt E
55 mm (2.17 in.)

NOTICE:
* When installing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and transaxle case to interfere with each other.
* Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
* First, temporarily tighten the bolts marked (*a) in the illustration because they are positioning bolts.

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

(a) Coat a new O-ring with ATF and install it to the oil strainer.

NOTICE:
Ensure that the O-ring is not twisted or pinched.

(b) Install the oil strainer to the valve body with the 2 bolts.

Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

(a) Install the 2 magnets onto the automatic transaxle oil pan as shown in the illustration.





Text in Illustration





(b) Install a new gasket to the oil pan.

(c) Install the oil pan to the automatic transaxle with the 17 bolts.





Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

(d) Clean and degrease the bolt and the installation hole in the automatic transaxle.





(e) Apply adhesive to the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

(f) Install the bolt.

Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)

NOTICE:
* In order to ensure proper sealing of the transmission oil pan bolts, apply adhesive to the bolts and install them within 10 minutes of adhesive application.
* Completely remove any oil or grease from the contact surface of the transaxle case and oil pan sub-assembly with the gasket before installation.

5. INSTALL TORQUE CONVERTER ASSEMBLY Installation

6. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

Installation