Installation

STEERING COLUMN: STEERING COLUMN ASSEMBLY: INSTALLATION

1. INSPECT STEERING COLUMN ASSEMBLY Component Tests and General Diagnostics

2. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY

(a) Install the steering intermediate shaft assembly to the steering column assembly.





Text in Illustration





NOTICE:
Align the matchmarks on the steering intermediate shaft assembly and the steering column assembly.

(b) Install the bolt.

Torque : 35 Nm (360 kgf-cm, 26 ft-lbf)

3. INSTALL STEERING POST ASSEMBLY

(a) Install the steering post assembly with the 4 nuts.

Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)

(b) Install the ground wire with the bolt.

Torque : 8.4 Nm (85 kgf-cm, 74 in-lbf)

(c) Engage the clamp.

(d) Connect the 2 connectors.

(e) Connect the connectors and engage the wire harness clamps to the steering post assembly.

4. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

(a) Engage the 2 claws and guide to install the No. 2 air duct sub-assembly.

5. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

(a) Connect the steering intermediate shaft assembly to the steering link assembly.





Text in Illustration





NOTICE:
Align the matchmarks on the steering intermediate shaft assembly and the steering link assembly.

(b) Install the bolt.

Torque : 35 Nm (360 kgf-cm, 26 ft-lbf)

(c) Tighten the clamp.





6. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

NOTICE:
* Do not replace the spiral cable with the battery connected and the ignition switch ON.
* Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

(a) Engage the 3 claws to install the turn signal switch assembly with spiral cable sub-assembly to the steering post assembly.

(b) Connect the connectors to the turn signal switch assembly with spiral cable sub-assembly.

7. INSTALL UPPER STEERING COLUMN COVER

(a) Engage the 2 claws to install the upper steering column cover.

(b) Engage the 4 clips and 2 guides to the upper steering column cover.

8. INSTALL LOWER STEERING COLUMN COVER

(a) Engage the 2 claws to install the lower steering column cover.





(b) Install the 2 screws.





Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

(c) Engage the claw.





9. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

10. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Installation

11. INSTALL STEERING WHEEL ASSEMBLY (for 3 Spoke) Installation

12. INSTALL STEERING WHEEL ASSEMBLY (for 4 Spoke) Installation

13. INSPECT STEERING WHEEL CENTER POINT

14. INSTALL HORN BUTTON ASSEMBLY

Installation

15. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Installation

16. INSTALL FRONT WHEEL LH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

17. TORQUE SENSOR ZERO POINT CALIBRATION (for 2AR-FE without Wireless Door Lock)



18. TORQUE SENSOR ZERO POINT CALIBRATION (for 2AR-FE with Wireless Door Lock)