Installation

2GR-FE ENGINE CONTROL: THROTTLE BODY: INSTALLATION

1. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY

(a) Install a new gasket to the intake air surge tank assembly.





(b) Install the throttle with motor body assembly and wire harness clamp stay to the intake air surge tank assembly with the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the throttle body connector and wire harness clamp.

(d) Connect the 2 water by-pass hoses to the throttle with motor body assembly.

2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

(a) Connect the air cleaner cap sub-assembly to the throttle with motor body assembly with the hose clamp.

(b) Install the air cleaner cap with hose to the air cleaner case with the 2 clamps.

(c) Connect the wire harness clamp and mass air flow meter connector.

(d) Connect the 3 hoses.

(e) Connect the ventilation hose.

(f) Connect the mass air flow meter connector and wire harness clamp.

3. ADD ENGINE COOLANT Service and Repair

4. INSPECT FOR COOLANT LEAK Testing and Inspection

5. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

6. INSTALL ENGINE UNDER COVER RH

7. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

8. INSTALL ENGINE UNDER COVER LH

9. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

10. PERFORM INITIALIZATION

NOTICE:
* Be sure to perform this procedure after reassembling the throttle with motor body assembly or removing and reinstalling any throttle body component.
* Perform the following procedure after replacing the throttle with motor body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.

(a) Turn the engine switch on (IG) without operating the accelerator pedal.

NOTICE:
If the accelerator pedal is operated, perform the above steps again.

(b) Connect the Techstream to the DLC3 and clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(c) Perform the "Inspection After Repair" Programming and Relearning.

(d) Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

Standard:





NOTICE:
* Be sure to perform this step with all accessories off.
* Make sure that the shift lever is in neutral.

(e) Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

(f) Perform a road test and confirm that there are no abnormalities.