Installation

REAR SUSPENSION: REAR STABILIZER BAR: INSTALLATION

1. INSTALL REAR STABILIZER BUSHING (for LH Side)

(a) Install the rear stabilizer bushing to the outside of the stopper ring on the rear stabilizer bar as shown in the illustration.





Text in Illustration





NOTICE:
Install the rear stabilizer bushing so that the cutout face rearward.

2. INSTALL REAR STABILIZER BUSHING (for RH Side)

HINT
Perform the same procedure as for the LH side.

3. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for LH Side)

(a) Install the rear No. 1 stabilizer bar bracket to the rear stabilizer bar.





Text in Illustration





NOTICE:
Be sure to install the rear No. 1 stabilizer bar bracket in the correct direction.

4. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for RH Side)

HINT
Perform the same procedure as for the LH side.

5. INSTALL REAR NO. 2 STABILIZER BAR BRACKET (for LH Side)

(a) Install the rear No. 2 stabilizer bar bracket to the rear stabilizer bar.





6. INSTALL REAR NO. 2 STABILIZER BAR BRACKET (for RH Side)

HINT
Perform the same procedure as for the LH side.

7. INSTALL REAR STABILIZER BAR

(a) Install the rear stabilizer bar with the 4 bolts.





Text in Illustration





Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)

8. INSTALL REAR STABILIZER LINK ASSEMBLY LH

(a) Install the rear stabilizer link assembly LH to the rear shock absorber with coil spring with the nut.

Torque : 39 Nm (400 kgf-cm, 29 ft-lbf)

If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.

(b) Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut.

Torque : 39 Nm (400 kgf-cm, 29 ft-lbf)

If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.

9. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT
Perform the same procedure as for the LH side.

10. INSTALL NO. 2 FLOOR UNDER COVER (w/ Floor Under Cover)

(a) Install the No. 2 floor under cover with the 2 bolts, 3 nuts and 2 clips.

Bolt - Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

Nut - Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)

11. INSTALL NO. 1 FLOOR UNDER COVER

(a) Install the No. 1 floor under cover with the 2 bolts, 3 nuts and 2 clips.

Bolt - Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

Nut - Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)

12. INSTALL REAR WHEELS

Torque : 103 Nm (1049 kgf-cm, 76 ft-lbf)