ABS Warning Light Remains ON

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: ABS Warning Light Remains ON
- ABS Warning Light Remains ON

DESCRIPTION

The skid control ECU is connected to the combination meter assembly via CAN communication.

If any of the following is detected, the ABS warning light remains on:

* The skid control ECU connector is disconnected from the skid control ECU.

* There is a malfunction in the skid control ECU internal circuit.

* There is an open in the harness between the combination meter assembly and the skid control ECU.

* The ABS control system is defective.

HINT
In some cases, the Techstream cannot be used when the skid control ECU is abnormal.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output Diagnosis System.

Result:





B -- INSPECT CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED

(a) Check if the skid control ECU connector is securely connected.

OK:

The connector is securely connected.

NG -- CONNECT CONNECTOR TO ECU CORRECTLY
OK -- Continue to next step.

3. CHECK BATTERY

(a) Check the battery voltage.

Standard Voltage:

11 to 14 V

Result:





B -- CHECK OR REPLACE CHARGING SYSTEM COMPONENT OR BATTERY Component Tests and General Diagnostics

C -- CHECK OR REPLACE CHARGING SYSTEM COMPONENT OR BATTERY Component Tests and General Diagnostics
A -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)

(a) Disconnect the skid control ECU connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (GND1 TERMINAL)

(a) Turn the ignition switch off.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GND1 CIRCUIT)
OK -- Continue to next step.

6. INSPECT COMBINATION METER ASSEMBLY

(a) Reconnect the skid control ECU connector.

(b) Perform an Active Test of the combination meter assembly (meter CPU) using the Techstream Meter / Gauge System.

(c) Check the combination meter assembly.

OK:

The ABS warning light turns on or off in accordance with the Active Test operation.

HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts Problem Symptoms Table.

NG -- REPLACE COMBINATION METER ASSEMBLY Removal

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal