Removal

DOOR / HATCH: LUGGAGE DOOR LOCK CONTROL CABLE ASSEMBLY: REMOVAL

1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT SEAT ASSEMBLY LH (for TMMK Made Manual Seat)

Removal

4. REMOVE FRONT SEAT ASSEMBLY LH (for TMMK Made Power Seat)

Removal

5. REMOVE FRONT SEAT ASSEMBLY LH (for SIA Made Manual Seat)

Removal

6. REMOVE FRONT SEAT ASSEMBLY LH (for SIA Made Power Seat)

Removal

7. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

8. REMOVE REAR SEAT CUSHION LOCK HOOK Removal

9. REMOVE REAR SIDE SEATBACK ASSEMBLY LH Removal

10. REMOVE FRONT DOOR SCUFF PLATE LH Removal

11. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH Removal

12. REMOVE REAR DOOR SCUFF PLATE LH Removal

13. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH Removal

14. REMOVE LAP BELT OUTER ANCHOR COVER Removal

15. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Removal

16. REMOVE CENTER PILLAR LOWER GARNISH LH Removal

17. REMOVE LUGGAGE COMPARTMENT DOOR COVER Disassembly

18. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal

19. REMOVE SPARE WHEEL COVER ASSEMBLY Removal

20. REMOVE BAGGAGE HOLDER NET (w/ Partition Net) Removal

21. REMOVE REAR FLOOR FINISH PLATE Removal

22. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

(a) Push the pin and remove the No. 1 luggage compartment trim hook.

Text in Illustration

23. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH Removal

24. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY

(a) Remove the screw.

(b) Disengage the guide and disconnect the fuel lid lock open lever sub-assembly as shown in the illustration.

(c) Disconnect the fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly and remove the fuel lid lock open lever sub-assembly.

25. REMOVE LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY

(a) Disengage the 2 clamps.

(b) Using a clip remover, disengage the clamp and disconnect the wire harness.

(d) Turn back the floor carpet so that the luggage door lock control cable sub-assembly and fuel lid lock control cable sub-assembly can be removed.

(e) w/o Wireless Door Lock Control System:

(1) Disconnect the luggage door lock control cable sub-assembly.

(2) Disengage the 3 clamps and disconnect luggage door lock control cable sub-assembly.

(f) w/ Wireless Door Lock Control System:

(1) Disengage the guide as shown in the illustration.

(2) Disconnect the luggage door lock control cable sub-assembly.

(3) Disengage the clamp and disconnect the luggage door lock control cable sub-assembly.

(g) Rotate the fuel filler opening lid lock retainer as shown in the illustration to align the cutouts and the guides [A], and then pull the fuel filler opening lid lock retainer.

Text in Illustration

(h) Rotate the fuel filler opening lid lock retainer as shown in the illustration to align the cutouts and guides [B], and then pull the fuel filler opening lid lock retainer.

Text in Illustration

(i) Pull out the fuel filler opening lid lock retainer with both guides [B and C] aligned with the cutouts.

Text in Illustration

(j) Disengage the 2 claws and remove the fuel filler opening lid lock retainer.

(k) Disengage the 10 clamps and remove the fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly.

Text in Illustration

(l) Using a knife, cut off the clamp as shown in the illustration.

Text in Illustration

NOTICE:
Be careful not to damage the vehicle fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly.

(m) Remove the clamp.

(n) Remove the 3 pieces of tape and fuel lid lock control cable sub-assembly.