Removal

C50 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN TRANSAXLE OIL

(a) Remove the filler plug and the gasket.

(b) Remove the drain plug and gasket, and then drain the manual transaxle oil.

(c) Install a new gasket and the drain plug.

Torque : 39 Nm (400 kgf-cm, 29 ft-lbf)

3. REMOVE FRONT WHEELS

4. REMOVE FRONT AXLE SHAFT LH NUT Removal

5. REMOVE FRONT AXLE SHAFT RH NUT

HINT
The removal procedure for the RH side is the same as that for the LH side.

6. SEPARATE SPEED SENSOR FRONT LH (w/ ABS) Removal

7. SEPARATE SPEED SENSOR FRONT RH (w/ ABS)

HINT
The separation procedure for the RH side is the same as that for the LH side.

8. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH Removal

9. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

10. SEPARATE TIE ROD END SUB-ASSEMBLY LH Removal

11. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

12. SEPARATE FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH Removal

13. SEPARATE FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

14. SEPARATE FRONT AXLE ASSEMBLY LH Removal

15. SEPARATE FRONT AXLE ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

16. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

17. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

18. REMOVE TRANSAXLE CASE OIL SEAL





(a) Using SST, remove the oil seal.

SST : 09308-00010

19. REMOVE TRANSMISSION CASE OIL SEAL





(a) Using SST, remove the oil seal.

SST : 09308-00010