Removal

U340E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WHEELS

3. REMOVE ENGINE UNDER COVER LH

4. REMOVE ENGINE UNDER COVER RH

5. DRAIN AUTOMATIC TRANSAXLE FLUID

(a) Remove the drain plug and gasket, and drain the automatic transaxle fluid.

(b) Install a new gasket and the drain plug.

Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)

6. REMOVE FRONT AXLE HUB NUT LH Removal

7. REMOVE FRONT AXLE HUB NUT RH

HINT
The removal procedure for the RH side is the same as that for the LH side.

8. SEPARATE FRONT SPEED SENSOR LH (w/ ABS) Removal

9. SEPARATE FRONT SPEED SENSOR RH (w/ ABS)

HINT
The separation procedure for the RH side is the same as that for the LH side.

10. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH Removal

11. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

12. SEPARATE TIE ROD END SUB-ASSEMBLY LH Removal

13. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

14. SEPARATE FRONT LOWER SUSPENSION ARM LH Removal

15. SEPARATE FRONT LOWER SUSPENSION ARM RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

16. SEPARATE FRONT AXLE ASSEMBLY LH Removal

17. SEPARATE FRONT AXLE ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

18. REMOVE AUTOMATIC TRANSMISSION CASE PROTECTOR (w/o ABS)





(a) Remove the 2 bolts and remove the transmission case protector from the automatic transaxle.

19. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

20. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

21. REMOVE FRONT TRANSAXLE CASE OIL SEAL





(a) Using SST, remove the front transaxle case oil seal.

SST : 09308-00010

22. REMOVE TRANSAXLE CASE OIL SEAL





(a) Using SST, remove the transaxle case oil seal.

SST : 09308-00010