TC and CG Terminal Circuit

BRAKE CONTROL: ANTI-LOCK BRAKE SYSTEM (for Hatchback): TC and CG Terminal Circuit
- TC and CG Terminal Circuit

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light.

WIRING DIAGRAM





HINT
When the warning lights continue to blink, there may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if CAN communication system DTCs are output Diagnosis System.

Result

Result:

B -- CHECK CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. INSPECT DLC3

(a) Turn the ignition switch to ON.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Result

Result:

B -- INSPECT ECM (TC of DLC3 INPUT)
A -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)

(a) Turn the ignition switch off.





(b) Disconnect the ECM connector.

(c) Inspect the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. INSPECT ECM (TC of DLC3 INPUT)

(a) Turn the ignition switch off.





(b) Reconnect the ECM connector.

(c) Using SST, connect terminals TC and CG of the DLC3.

(d) Turn the ignition switch to ON.

(e) Check that the check engine warning light is blinking.

Result

Result:

B -- INSPECT SFI SYSTEM Testing and Inspection

A -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal