ABS Warning Light does not Come ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ABS Warning Light does not Come ON
- ABS Warning Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON ABS Warning Light Remains ON.

INSPECTION PROCEDURE

NOTICE:
* When replacing the brake actuator assembly, perform zero point calibration Programming and Relearning.
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if CAN communication system DTCs are output Diagnosis System.

Result

Result:

B -- CHECK CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. CHECK ABS WARNING LIGHT

(a) Disconnect the skid control ECU connector.

(b) Turn the ignition switch to ON.

(c) Check that the ABS warning light comes on.

OK:

The ABS warning light comes on.

NG -- INSPECT COMBINATION METER ASSEMBLY

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal

3. INSPECT COMBINATION METER ASSEMBLY

(a) Turn the ignition switch off.

(b) Reconnect the skid control ECU connector.

(c) Connect the Techstream to the DLC3.

(d) Perform Active Test of the combination meter using the Techstream.

* for Sedan Meter / Gauge System (for Sedan).

* for Hatchback Meter / Gauge System (for Hatchback).

OK:

The ABS warning light turns ON or OFF in accordance with the Techstream.

Result

Result:

C -- REPLACE COMBINATION METER ASSEMBLY Removal

B -- REPLACE COMBINATION METER ASSEMBLY Removal

A -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal