Ignition Coil: Service and Repair

IGNITION COIL REMOVAL AND INSTALLATION

- REMOVE DISTRIBUTOR CAP
- REMOVE ROTOR
- REMOVE IGNITION COIL DUST COVER
- Remove the dust cover and gasket.
- REMOVE IGNITION COIL





- Remove the 2 nuts, and disconnect the 3 wires from the ignition coil terminals.





- Remove the 4 screws and ignition coil.

INSTALL IGNITION COIL





- Remove any old packing (FIPG) material.
- Apply seal packing to the ignition coil installing surface of the housing as shown in the illustration.

Seal packing:
Part No. 08826-00080 or equivalent

- Install the ignition coil with the 4 screws.





- Connect the 3 wires to the ignition coil terminals with the 2 nuts as shown in the illustration.





NOTICE:
- When connecting the wires to the Ignition coil, Insert both properly into their grooves found on the side of the ignition coil.
- Be sure the wires do not contact with signal rotor or distributor housing.

- INSTALL IGNITION COIL DUST COVER
- Install a new gasket to the distributor housing.
- Install the dust cover.
- INSTALL ROTOR
- INSTALL DISTRIBUTOR CAP