Removal

3UR-FE STARTING: STARTER:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
- Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE NO. 1 ENGINE UNDER COVER (Replacement)

3. REMOVE V-BANK COVER SUB-ASSEMBLY (Removal)

4. REMOVE AIR CLEANER HOSE ASSEMBLY (Removal)

5. REMOVE AIR CLEANER ASSEMBLY (Removal)

6. REMOVE FAN AND GENERATOR V BELT (Removal)

7. REMOVE FRONT FENDER APRON SEAL RH (Removal)

8. DISCONNECT VANE PUMP ASSEMBLY

(a) Disconnect the 2 clamps and power steering oil pressure switch connector.

(b) Remove the 2 bolts and disconnect the vane pump.
9. REMOVE GENERATOR ASSEMBLY

(a) Disconnect the generator connector.
(b) Remove the terminal cap and nut, and disconnect the generator wire.

(d) Remove the 2 bolts, 2 nuts and generator.
10. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
(a) Remove the dipstick.

(b) Remove the bolt and dipstick guide.
(c) Remove the O-ring from the dipstick guide.
11. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Disconnect the air fuel ratio sensor connector.
(b) Disconnect the heated oxygen sensor connector and 2 clamps.
(c) Remove the 2 bolts.
(d) Remove the 3 nuts and front exhaust pipe.
(e) Remove the 2 gaskets.
12. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR (Removal)

13. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH (Removal)

14. REMOVE STARTER COVER

(a) Remove the 3 bolts and starter cover.
15. REMOVE STARTER ASSEMBLY

(a) Disconnect the starter connector.
(b) Remove the nut and disconnect the starter wire.

(d) Remove the flywheel housing side cover.