Installation

POWER STEERING: VANE PUMP (for 2TR-FE):

INSTALLATION

1. INSTALL VANE PUMP





(a) Install the vane pump assembly with the 2 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)





(b) Connect the oil pressure switch connector.

NOTE: Make sure that no oil adheres to the connector.

2. CONNECT PRESSURE FEED TUBE ASSEMBLY





(a) Install a new gasket onto the pressure feed tube.
(b) Install the pressure feed tube with the union bolt.
Torque: 51 Nm (520 kgf-cm, 38 ft-lbf)





(c) Connect the return hose with the clip.
3. INSTALL FAN AND GENERATOR V BELT

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)

5. ADD POWER STEERING FLUID
6. BLEED POWER STEERING FLUID (Power Steering System)

7. CHECK POWER STEERING FLUID LEAKAGE
8. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO. 1 (for 4WD and Pre-Runner)
Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)