Installation

U151F AUTOMATIC TRANSAXLE: SHIFT LEVER: INSTALLATION

INSTALLATION

1. INSTALL SHIFT LEVER ASSEMBLY






(a) Install shift lever assembly to the vehicle with the 4 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
NOTE: Into datum hole of shift lever into datum pin of instrument lower.

(b) Connect the 2 connectors to the shift lever assembly.
2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY






(a) Install the cable outer to the shift lever plate






(b) When installing the transmission control cable assembly on the shift lever plate, place the projection to the shift lever plate (FIG. 2).
Confirm that the spring in the shift cable outer has moved to the position (FIG. 3) shown in the illustration.
Confirm that the shift cable is installed on the shift lever plate properly.
- To prevent torsion of the inner cable, the projection on the eye end should face rear.
- Push the cable end to the bottom of the pin.

3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER

4. INSTALL SHIFT LEVER CAP






(a) Install the shift lever cap to the floor shift position indicator housing assembly.
5. INSTALL POSITION INDICATOR HOUSING ASSEMBLY






(a) install the position indicator housing assembly to the instrument cluster finish panel assembly center.
6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY






(a) install the shift lever knob sub-assembly.
7. ADJUST SHIFT LEVER POSITION Adjustments

8. INSPECT SHIFT LEVER POSITION Adjustments

9. INSPECT KEY INTER LOCK OPERATION Testing and Inspection

10. INSPECT SHIFT LOCK OPERATION Testing and Inspection

11. INSPECT SHIFT LOCK RELEASE BUTTON OPERATION Testing and Inspection