ABS Warning Light does not Come ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ABS Warning Light does not Come ON

ABS Warning Light does not Come ON

WIRING DIAGRAM






INSPECTION PROCEDURE

PROCEDURE

1. CHECK ABS WARNING LIGHT
(a) Disconnect the skid control ECU connector.
(b) Turn the ignition switch to the ON position.
(c) Check that the ABS warning light comes on.
OK:
ABS warning light comes on.
HINT: If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step Problem Symptoms Table.

NG -- CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)
OK -- REPLACE BRAKE ACTUATOR ASSEMBLY
2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)
(a) Turn the ignition switch off.
(b) Disconnect the combination meter connector.





(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT COMBINATION METER ASSEMBLY
(a) Check the combination meter How To Proceed With Troubleshooting.
HINT: If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step Problem Symptoms Table.

NG -- REPLACE COMBINATION METER ASSEMBLY
OK -- END