Removal

BRAKE (REAR): REAR BRAKE: REMOVAL

REMOVAL

1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTE: Wash brake fluid off immediately if it is spilled on any painted surface.





3. DISCONNECT REAR FLEXIBLE HOSE LH
(a) Remove the union bolt and gasket, and then disconnect the flexible hose from the rear disc brake cylinder. Use a container to catch brake fluid as it drains out.






4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH
(a) Remove the 2 slide pins.
(b) Remove the caliper from the rear disc brake cylinder mounting.
5. REMOVE REAR DISC BRAKE PAD KIT
(a) Remove the 2 brake pads from the rear disc brake cylinder mounting.
6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
(a) Remove the 2 anti-squeal shims from each disc brake pad.
7. REMOVE PAD WEAR INDICATOR PLATE
(a) Remove the pad wear indicator plate from the inner side disc brake pad.
8. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
NOTICE:
- The pad supports are attached to the rear disc brake cylinder mounting with double-sided tape. After removing the brakes pads, make sure the pad supports are not detached. If the pads supports are not detached, they can be reused. If they are detached, replace the pad supports with new ones.
- If the pad supports are removed during maintenance of parts, replace them with new ones.

(a) Remove the 4 pad support plates from the rear disc brake cylinder mounting.
9. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH






(a) Remove the 2 bolts and rear disc brake cylinder mounting.
NOTE: If the pad supports are removed during maintenance of parts, replace them with new ones.

(b) Remove the 2 boots from the rear disc brake cylinder mounting.
10. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
11. REMOVE REAR DISC






(a) Put matchmarks on the rear disc and axle hub if planning to reuse the disc.






(b) Turn the shoe adjuster until the disc turns freely, and then remove the disc.