Installation

WIPER AND WASHER: REAR WIPER MOTOR: INSTALLATION

INSTALLATION





1. INSTALL REAR WIPER MOTOR ASSEMBLY
(a) Install the wiper motor with the 3 bolts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
(b) Connect the connector.
2. INSTALL REAR WIPER MOTOR GROMMET
3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
(a) Stop the wiper motor at the automatic stop position.






(b) Clean the wiper arm serration with a round file or equivalent.
(c) Clean the wiper pivot serration with a wire brush.






(d) Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
- Hold down the arm hinge by hand while tightening the nut.
- Install the arm and blade so that the rear wiper blade is aligned with the ceramic line.





(e) Install the cap.
4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Reassembly

5. INSTALL BACK DOOR SIDE GARNISH RH Reassembly

6. INSTALL BACK DOOR SIDE GARNISH LH Reassembly

7. INSTALL BACK DOOR CENTER GARNISH Reassembly

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL