Removal

2AZ-FE COOLING: WATER PUMP: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE NO. 1 ENGINE UNDER COVER
3. REMOVE FRONT FENDER APRON RH
4. REMOVE RADIATOR SUPPORT OPENING COVER
5. DRAIN ENGINE COOLANT Service and Repair

6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH Removal

7. REMOVE FAN AND GENERATOR V BELT Removal

8. REMOVE GENERATOR ASSEMBLY

9. REMOVE WATER PUMP PULLEY
(a) Using SST, remove the 4 bolts and water pump pulley.
SST: 09960-10010
09962-01000
09963-00700
10. REMOVE WATER PUMP ASSEMBLY

(a) Remove the clamp of the crankshaft position sensor from the water pump.
(b) Disconnect the wire of the crankshaft position sensor from the clamp bracket.

(d) Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
NOTE: Be careful not to damage the contact surfaces of the water pump and cylinder block.