Installation

3UR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

INSTALLATION

1. INSTALL FAN AND GENERATOR V BELT






(a) Set the V belt onto every part.
(b) While turning the belt tensioner counterclockwise, remove the bar.
NOTE: Make sure that the V belt is properly set to each pulley.





(c) After installing the belt, check that it fits properly in the ribbed grooves.
HINT: Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

2. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation

4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH