Installation

DIFFERENTIAL: FRONT DIFFERENTIAL CARRIER ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY





(a) Install the front No. 3 differential support with the 2 bolts.
Torque: 108 Nm (1,100 kgf-cm, 80 ft-lbf)






(b) Install the front No. 2 differential support with the 2 bolts.
Torque: 160 Nm (1,630 kgf-cm, 11 ft-lbf)






(c) Install the front No. 1 differential support with the 3 bolts.
Torque: 186 Nm (1,900 kgf-cm, 137 ft-lbf)
(d) Support the front differential with a jack.






(e) Install the 2 front mounting bolts and 2 nuts.
Torque: 137 Nm (1,400 kgf-cm, 101 ft-lbf)
(f) Install front differential mounting nut No. 1.
Torque: 87 Nm (887 kgf-cm, 64 ft-lbf)
(g) Install the front differential breather tube bracket with the bolt.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
(h) Lower the jack.
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
HINT: Use the same procedure as for the LH side.

4. INSTALL FRONT LOWER BALL JOINT ATTACHMENT Installation

5. INSTALL TIE ROD END SUB-ASSEMBLY LH Installation

6. INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT: Use the same procedure as for the LH side.

7. INSTALL FRONT AXLE HUB NUT LH Installation

8. INSTALL FRONT AXLE HUB NUT RH
HINT: Use the same procedure as for the LH side.

9. INSTALL FRONT AXLE HUB GREASE CAP
10. INSTALL FRONT SPEED SENSOR LH Installation

11. INSTALL FRONT SPEED SENSOR RH
HINT: Use the same procedure as for the LH side.

12. INSTALL FRONT WHEEL
Torque: 112 Nm (1,137 kgf-cm, 82 ft-lbf)
13. INSPECT DIFFERENTIAL OIL Testing and Inspection

14. CHECK FOR DIFFERENTIAL OIL LEAKAGE
15. INSTALL REAR ENGINE UNDER COVER ASSEMBLY
16. INSTALL NO. 1 ENGINE UNDER COVER
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
18. CHECK VSC SENSOR SIGNAL
Test Mode Procedure
19. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Service and Repair