Slip Indicator Light Remains ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light Remains ON

Slip Indicator Light Remains ON

DESCRIPTION

- The SLIP indicator blinks when any of the TRAC, VSC and AUTO LSD operate.
- When the system fails, the SLIP indicator light illuminates to warn the driver.

WIRING DIAGRAM





INSPECTION PROCEDURE
NOTE: When replacing the master cylinder solenoid, perform zero point calibration Programming and Relearning.

PROCEDURE

1. CHECK DTC
(a) Check for the DTCs Reading and Clearing Diagnostic Trouble Codes.
Result:






B -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)





(a) Disconnect the skid control ECU connector.
(b) Disconnect the combination meter connector.
(c) Measure the resistance.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT COMBINATION METER ASSEMBLY
(a) Check the combination meter system Meter / Gauge System.
OK:
Combination meter is normal.
NG -- REPLACE COMBINATION METER ASSEMBLY
OK -- REPLACE MASTER CYLINDER SOLENOID