Removal

1GR-FE STARTING: STARTER (for Standard): REMOVAL

1GR-FE STARTING: STARTER

1. DISCONNECT BATTERY NEGATIVE TERMINAL (for 2WD)
(a) Disconnect the battery negative terminal.
2. REMOVE ENGINE REAR UNDER COVER ASSEMBLY (for 2WD)
(a) Remove the 4 bolts and engine rear under cover assembly.
3. REMOVE NO. 2 MANIFOLD STAY (for 2WD)
(a) Remove the 3 bolts and No. 2 manifold stay.
4. DISCONNECT WIRE HARNESS (for 2WD)
(a) Remove the bolt and disconnect the wire harness from the cylinder block.
5. REMOVE STARTER ASSEMBLY (for 2WD)
(a) Disconnect the terminal 50 connector from the starter assembly.
(b) Remove the nut and disconnect the wire harness from the terminal 30.
(c) Remove the 2 bolts and starter assembly.
6. DISCONNECT BATTERY NEGATIVE TERMINAL (for 4WD)
(a) Disconnect the battery negative terminal.
7. REMOVE ENGINE REAR UNDER COVER ASSEMBLY (for 4WD)
(a) Remove the 4 bolts and engine rear under cover assembly.
8. REMOVE NO. 2 FRONT EXHAUST PIPE ASSEMBLY (for 4WD)
(a) Disconnect the heated oxygen sensor (bank 2) connector.
(b) Remove the 2 bolts, 2 nuts, No. 2 front exhaust pipe assembly and 2 gaskets.
9. REMOVE FRONT FENDER REAR SPLASH SHIELD LH (for 4WD)






(a) Remove the 5 clips and front fender rear splash shield LH.
10. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY (for 4WD)






(a) Loosen the bolt A and remove the bolt B, then separate the No. 2 steering intermediate shaft sub-assembly.
11. REMOVE STARTER ASSEMBLY (for 4WD)
(a) Disconnect the terminal 50 connector from the starter assembly.
(b) Remove the nut and disconnect the wire harness from the terminal 30.
(c) Remove the 2 bolts and starter assembly.