Removal and Installation

Compressor Components (5VZ-FE):

REMOVAL
1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES WITH A/C ON
2. STOP ENGINE
3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY
4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
5. REMOVE ENGINE UNDER COVER
6. DISCONNECT DISCHARGE AND SUCTION HOSES
Remove the 2 bolts and disconnect the both hoses.

NOTE: Cap the open filling immediately to keep moisture or dirt out of the system.

7. REMOVE DRIVE BELT
Drive Belt Tension/Replacement

8. 5VZ-FE Engine Models:
REMOVE PS PUMP WITH TUBE AND HOSE

9. REMOVE COMPRESSOR
a. Disconnect the connector.
b. Remove the 4 bolts and compressor.


INSTALLATION
1. INSTALL COMPRESSOR
a. Install the compressor with 4 bolts.

Torque: 25 N.m (250 kgf.cm, 18 ft.lbf)

b. Install fan shroud.
c. Connect the connector.

2. INSTALL DRIVE BELT AND CHECK DRIVE BELT
Drive Belt Tension/Replacement

3. CONNECT DISCHARGE AND SUCTION HOSES

Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)

NOTE: Hoses should be connected immediately after the caps have been removed.

HINT: Lubricate 2 new O-rings with compressor oil and install the hoses.

4. INSTALL ENGINE UNDER COVER



5. 5VZ-FE Engine Models:
INSTALL PS PUMP

Torque: 43 N.m (440 kgf.cm, 32 ft.lbf)

6. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY
7. EVACUATE AIR FROM REFRIGERATION SYSTEM
8. CHARGE SYSTEM WITH REFRIGERANT

Specified amount: 650 ± 50 g (22.92 ± 1.76 oz.)

9. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.