DTC 42

Camshaft Position Sensor Circuit Diagram:

Sensor signal not inputted for 2 seconds at engine cranking.

NOTE: If starter circuit is open (i.e., start signal circuit is OK but starter fails to run), code No.42 is stored in memory at starter switch ON, even though CMP sensor is in good condition. When starter motor fails to run and code No.42 appears, check starter circuit first.

NOTE: Upon completion of inspection and repair work, perform FINAL CHECK to confirm that the trouble has been corrected.

Final Check Procedure Flow Chart:

Final Driving Test For Codes Other Than No. 24:

FINAL CHECK
Upon completion of inspection and repair work related to the above diagnostic trouble code, perform the final check as described in the above images.

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.

- Road test should be carried out with 2 persons, a driver and a tester, on a level road.