38771900 Removing and installing control mechanism for transmission

WM 387719 Removing and installing control mechanism for transmission

Technical values





Information

Notes

Information

Fill only with ATF approved by Porsche. See Spare Parts Catalogue.

Information

Hot vehicles should cool down before beginning the activity.

Information

Vehicle must be horizontal in order to be filled and checked.

Filling capacities





Preliminary work

1. Raise the vehicle at the prescribed jacking points. -> 400000 Lifting the vehicle
2. Remove support plate. -> 421419 Removing and installing support plate - section on "Removing" 42141900 Removing and installing support plate
3. Drain ATF.
4. Remove ATF pan. -> 375519 Removing and installing ATF pan - section on "Removing" 37551900 Removing and installing ATF pan
5. Remove ATF filter. -> 375855 Replacing ATF filter - section on "Removing" 37585500 Replacing ATF filter

Removing control mechanism for transmission

1. Pull off securing clasp for wiring harness plug.





Securing clasp

2. Pull off transmission speed connector.





Transmission speed connector

3. Unscrew designated fastening screws for hydraulic control unit.





Fastening screws

Information

Do not set down removed control mechanism for transmission on transmission input speed sender (rear of control mechanism). This can damage the sender.

4. Removed control mechanism from transmission and follow up wiring harness plug.

Installing control mechanism for transmission

1. Thinly coat toroidal sealing ring for wiring harness plug with Vaseline and insert plug into transmission housing.
2. Carefully position control mechanism and insert pin -1- of detent disc into groove of selector valve -2-.





Inserting control mechanism

3. Screw in fastening screws for control mechanism until hand-tight.





Fastening screws

4. Tighten fastening screws from inside outwards.





5. Attach securing clasp for wiring harness plug and engage holding tongue.





Securing clasp

Subsequent work

1. Install ATF filter. -> 375855 Replacing ATF filter - section on "Installing" 37585500 Replacing ATF filter
2. Install ATF pan. -> 375519 Removing and installing ATF pan - section on "Installing" 37551900 Removing and installing ATF pan
3. Fill in ATF.
4. Install support plate. -> 421419 Removing and installing support plate - section on "Installing" 42141900 Removing and installing support plate
5. Lower the vehicle.