Clutch Pedal Assembly: Service and Repair

Clutch Pedal Replacement

Removal Procedure

Important: Service the clutch pedal and bracket as an assembly.





1. Remove the clutch master cylinder pushrod from the clutch pedal.
2. Disconnect the clutch position and clutch cruise control switches.
3. Remove the clutch cruise control switch from the bracket.
4. Remove the instrument panel support beam.
5. Remove the instrument panel support beam bracket bolt.
6. Remove the clutch pedal and bracket mounting nuts.
7. Remove the clutch pedal and bracket assembly.

Installation Procedure





1. Install the clutch pedal and bracket assembly.

Notice: Refer to Fastener Notice in Service Precautions.





2. Install the clutch pedal and bracket mounting nuts.
Start with the lower nuts, tighten the nuts to 21 Nm (15 ft. lbs.).
3. Install the instrument support bracket bolt.
4. Install the instrument panel support beam.
5. Install the clutch master cylinder pushrod bushing on the pedal. Lubricate the bushing.
6. Install the clutch master cylinder pushrod to the clutch pedal.
7. Install the cruise control switch.
8. Connect the following components:
^ The cruise control switch
^ The clutch position switch