Removal and Installation

GENERATOR

Removal and Installation


REMOVAL

1.Remove hoodledge covers (RH and LH).
2.Remove cooling fan assembly. Removal and Installation.
3.Remove the A/C compressor. Service and Repair.
4.Remove A/C idler pulley.
5.Disconnect the oil pressure switch.
6.Disconnect the generator harness connectors.
7.Remove the generator bolt and nuts, using power tools.
8.Slide the generator out and remove.
9.Remove generator bracket.

INSTALLATION

Installation is in the reverse order of removal. Exploded View
- Temporarily tighten bolts and nut then tighten nut and bolts in the specified numerical order.

CAUTION:
Be sure to tighten "B" terminal nut carefully.
- Install generator and check tension of belt. Procedures.
- For this model, the power generation voltage variable control system that controls the power generation voltage of the generator has been adopted. Therefore, the power generation voltage variable control system operation inspection should be performed after replacing the generator, and then make sure that the system operates normally. System Description.