RH

ROCKER COVER

Removal and Installation RH


REMOVAL

1.Remove the engine room cover. Service and Repair.
2.Remove the front air duct and air duct hose and resonator assembly. Service and Repair.
3.Remove the intake manifold collector. Intake Manifold.
4.Remove ignition coils. RH.

CAUTION:
Never shock ignition coils.





5.Remove camshaft position sensors.

CAUTION:
- Handle carefully to avoid dropping and shocks.
- Do not disassemble.
- Do not allow metal powder to adhere to magnetic part at sensor tip (A).
- Do not place sensors in a location where they are exposed to magnetism.





6.Remove RH rocker cover bolts from cylinder head as shown.






INSTALLATION

Installation is in the reverse order of removal.





- Apply sealant to the areas on the front corners using Tool.
- Use Genuine Silicone RTV Sealant or equivalent. Recommended Chemical Products And Sealants.







CAUTION:
- Installation should be done within 5 minutes after applying liquid gasket.
- Do not fill the engine with oil for at least 30 minutes after the components are installed to allow the sealant to cure.
-Tighten the rocker cover bolts in two steps in order as shown.