LH

ROCKER COVER

Removal and Installation LH


REMOVAL

1.Remove the engine room cover. Service and Repair.
2.Remove front air duct. Service and Repair.
3.Remove blow by hose from rocker cover.





4.Remove camshaft position sensors.

CAUTION:
- Handle carefully to avoid dropping and shocks.
- Do not disassemble.
- Do not allow metal powder to adhere to magnetic part at sensor tip (A).
- Do not place sensors in a location where they are exposed to magnetism.
5.Disconnect the ignition coil connectors.
6.Remove the ignition coils. LH.

CAUTION:
Never shock ignition coils.





7.Remove LH rocker cover bolts from cylinder head as shown.







INSTALLATION

Installation is in the reverse order of removal.





- Apply sealant to the areas on the front corners using Tool.
- Use Genuine Silicone RTV Sealant or equivalent. Recommended Chemical Products And Sealants.






CAUTION:
- Installation should be done within 5 minutes after applying liquid gasket.
- Do not fill the engine with oil for at least 30 minutes after the components are installed to allow the sealant to cure.





-Tighten the rocker cover bolts in two steps in order as shown.