Data List Reference Table & Normal Scan Data Values
Part 1:
Part 2:
Part 3:
Part 4:
Part 5:
Part 6:
Part 7:
Part 8:
NOTE:
** For inspection procedures P0100 - P1900 refer to Trouble Code Diagnostic Procedures.
Testing and Inspection
** For inspection procedures 1 - 50 refer to Diagnosis By Symptom.
Symptom Related Diagnostic Procedures
CAUTION:
1. When shifting the select lever to D range, the brakes should be applied so that the vehicle does not move forward.
2. Driving tests always require another person.
NOTES FOR DATA LIST ITEMS BELOW
*1: When idling to warm up from an engine coolant temperature of approx. -20 °C (-4 °F), if the idling speed is lower than the standard value even when the IAC motor is fully opened, the air volume limiter built in the throttle body could be defective.
*2: The closed throttle position switch normally turns off when the voltage of the throttle position sensor is 50 - 100 mV higher than the voltage at the idle position. If the closed throttle position switch turns back on after the throttle position sensor voltage has risen by 100 mV and the throttle valve has opened, the closed throttle position switch and the throttle position sensor need to be adjusted.
*3: In a new vehicle [driven approximately 500 km (300 mile) or less], the volume air flow sensor output frequency is sometimes 10 % higher than the standard frequency.
*4: The injector drive time represents the time when the cranking speed is at 250 r/min or below when the power supply voltage is 11 V.
*5: In a new vehicle [driven approximately 500 km (300 mile) or less], the injector drive time is sometimes 10 % longer than the standard time.
*6: In a new vehicle [driven approximately 500 km (300 mile) or less], the servo valve position is sometimes 20 steps greater than the standard value.
* : Applicable to General Scan Tool (GST). When using the scan tool MB991502, GST item is displayed in alphabetical order after normal items are completed. Black and white letters are displayed in contrast with the normal items.